Studer BSP 1200, Руководство пользователя

Страница: 21 / 28

Studer Innotec SA
BSP
User Manual V1.0.3 21
With this function you can find the factory settings. For each parameter, not only the factory value is restored
but also the limits and the user level. This function is only accessible with the level installer.
7.4. Advanced settings {6016}
The advanced parameters for a BSP configuration.
7.4.1. Reset of user counters {6031}
This parameter allows to reset to zero the charge, discharge and time user counters of the Section 6.2.
7.4.2. Self discharge rate {6019}
A battery gets discharged over time even when no current is consumed. This parameter allows to take this
phenomenon into account.
7.4.3. Nominal temperature {6020}
The battery parameters are specified for a given temperature by their manufacturer. This parameter makes
it possible to modify that temperature.
7.4.4. Temperature coefficient {6021}
The available capacity diminishes with the decrease of the temperature. This coefficient enables to take this
factor into account.
7.4.5. Charge efficiency factor {6022}
During charging, less Ah are stored into the battery than during discharging. The ratio discharge/charge can
be set with this parameter.
7.4.6. Peukert's exponent {6023}
The capacity varies according to the discharge current (see Section 1.1.4). With this parameter one can set
the Peukert exponent that goes along with the nominal capacity {6001} and nominal discharge time .
7.4.7. Activate the end of charge synchronization {6042}
This parameter activates the function of synchronization at 100 % of SOC under certain conditions of end
of charge.
For the synchronization to occur:
• the voltage shall be above parameter {6024}
• the current shall be below parameter {6025}
• and this during a period defined by the parameter {6026}
This function is generally not necessary because the BSP adjusts automatically the state of charge as per
the voltage.
7.4.8. End of charge voltage level {6024}
See explanation at parameter {6042}.
7.4.9. End of charge current level {6025}
See explanation at parameter {6042}.
7.4.10. Minimum time before end of charge {6026}