3
connected with the outlet.Never let the power-cord come into contact with other cables! Handle the
power-cord and all connections with the mains with particular caution! Never touch them with wet
hands .as this could lead to mortal electrical shock. Never modify, bend, strain mechanically, put
pressure on, pull or heat up the power cord. Never operate next to sources of heat or cold. Disregard
can lead to power cord damages, fire or mortal electrical shock.The cable insert or the female part in the
device must never be strained. There must always be sufficient cable to the device. Otherwise, the
cable may be damaged which may lead to mortal electrical shock. Make sure that the power-cord is
never crimped or damaged by sharp edges. Check the device and the power-cord from time to time.If
extension cords are used, make sure that the core diameter is sufficient for the required power
consumption of the device. All warnings concerning the power cords are also valid for possible
extension cords.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power-cord by the plug. Never pull out the plug by tugging the power-cord. Otherwise, the cable or plug
can be damaged leading to mortal electrical shock. If the power plug or the power switch is not
accessible, the device must be the disconnected via the mains. If the power plug or the device is dusty,
the device must be take out of operation, disconnected and then be cleaned with a dry cloth, Dust can
reduce the insulation which may lead to mortal electrical shock. More severe dirt in and at the device
should only be removed by a specialist. There must never enter any liquid into power outlets, extension
cords or any holes in the housing of the device. If you suppose that also a minimal amount of liquid may
have exerted the device it must immediately be disconnected. This is also valid, if the device was
exposed to high humidity. Also if the device is still running, the device must be checking by a specialist if
the liquid has reduced any insulation. Reduced insulation can cause mortal electrical shock. There must
never be any objects entering into the device. This is especially valid for metal parts. If any metal parts
like staples or coarse metal chips enter into the device, the device must be taken out of operation and
disconnected immediately. Malfunction or short-circuits caused by metal parts my cause mortal injuries.
Never look directly into the light source, as sensitive persons may suffer an epileptic shock (especially
meant for epileptics)Keep away children and amateurs. Never leave this device running unattended.
OPERATING DETERMINATIONS
This device is designed for permanent operation. Consistent operation breaks will ensure that the
device will serve you for a long time without defects. Do not shake the device. Avoid brute force when
installing or operation the device. Never lift the fixture by holding it at the projector-head. As the
mechanics may be damaged.When choosing the installation-spot, please make sure that the device is
not exposed to extreme heat, moisture or dust. There should not be any cable lying around. Please
make sure that the fixture can not be touched or bumped. Your endanger your own and the safety of
others. This device must never be operated or stockpiled in surroundings’ where splash water, rain,
moisture or fog may harm the device. Moisture or very high humidity can reduce the insulation and lead
to mortal electrical shocks. When using smoking machines, make sure that the device is never exposed
to the direct smoke jet and is installed in a distance of 0.5 meters between smoke machine and device.
The room must only be saturated with an amount of smoke that the visibility will always be more then 10
The ambient temperature must always be between -5
0
C and + 45
0
C. keep away from direct
insulation(particularly in cars)and heaters .The relative humidity must not exceed 50% with an ambient
temperature of 45
0
C. This device must only be operated in an altitude between -20 and 2000m over NN.
