STS M2-D2, Руководство оператора

Страница: 31 / 69

31
M2-D
Set-up and Installation of M2 in detail
Permanent mounting of the unit
The M2 is built on a sub frame with isolators (pucks) attached to the bottom. The unit can be fastened
down to a permanent surface like a concrete pad, pull type trailer, flat deck of a truck or inside of a truck
body. Securing the unit with adequate size and grade of fasteners is the sole responsibility of the customer
and not of Surface to Surface Inc.
When fastening down the unit, care should be used when drilling holes to avoid such unseen items, as
gussets, cross-members, wiring or other fixtures below the surface.
Adequate space or an opening will also have to be considered when mounting, for the removal of the
filter / shear cartridge for regular cleaning and inspection.
Be aware of the engine exhaust
and how it will impact on the placement of the unit. If the unit is
to be mounted in an enclosed area the exhaust will have to be vented outside where it will not effect the
health of the operator or others working near the unit.
Portable use of the unit
If the M2 is to be used as a portable unit, there is a lifting bale (Fig.12) connected to the sub frame to
support and balance the unit when lifting or moving. Properly approved and rated lifting apparatus should
be used at all times and lifting done by qualified personal only.
The M2 should only be placed on solid, level ground with a clear working area around it.
CAUTION
LIFTING LUGS OR THE LIFTING POINT(S)
identified and labelled on the skid
structure must be used in order to
safely lift and transport the unit.
Fig.12
WARNING
REFER TO THE SAFETY
STATEMENTS IN THE
ENGINE OEM MANUAL
AND
THIS MANUAL
REGARDING THESE
OPERATIONS.