Stryker SwitchPoint Infinity 3, Руководство по эксплуатации и обслуживанию

Страница: 16 / 124

14
5
��������� �����������
5.1 Connectors Used by the SwitchPoint Infinity 3 Control
System
The SwitchPoint Infinity 3 Control System uses various commercial-grade video and
audio cables to interconnect equipment.
The primary types of cables are used in wiring video systems: Composite cables, which
have a BNC connector; RGB-HV cables, which have an HD-15 connector; S-Video
cables, which have a 4-pin mini-DIN connector; and DVI cables. BNC connectors are
push and turn type connectors; HD-15 connectors are push and screw type connectors;
and DIN connectors are push only type connectors. On some monitors, S-Video inputs
may be labeled Y/C or S-VHS, and RGB-HV inputs may be labeled PC, Computer, or
VGA.
The room speaker connection on the SwitchPoint Infinity 3 Control System uses a
Phoenix connector.
5.2 Connections Overview
5.2.1 Video Inputs
The number of video inputs is dependent upon each SwitchPoint Infinity Router. Source
inputs are available to receive video directly from Endoscopic and Room Cameras,
Printer, Digital Capture Device, Voice Control Device, and other video device outputs. All
of the connections are located on the front panel. For video input wiring, connect each
device output to an available video input on the SwitchPoint Infinity 3 Control System
connection panel.
5.2.2 Video Outputs
W Wa arrn niin ng g:: Do not touch the internal pin of the BNC video out jacks and the patient
simultaneously. Doing so may cause the patient to receive an electric shock.
The number of outputs is dependent upon each SwitchPoint Infinity Router. Outputs are
available to send video directly to flat panel displays, monitors, projectors, and other
video device inputs. All of the connections are located on the front panel. For video
output wiring, connect each device input to an available video output on the SwitchPoint
Infinity 3 Control System connection panel. When connected to a “loop-thru” video
device, the SwitchPoint Infinity 3 Control System will route the source to the device input
and receive the output signal from the device for further routing to a monitor (if selected).