Stryker S3 MEDSURG BED, Руководство по эксплуатации, Страница: 31 / 79

www.stryker.com 3006-209-001 REV B 27
Operation
Raising the siderails (Continued)
Figure 14: Siderail highest position
Lowering the siderails
WARNING
• Always set the siderail position to make sure that a patient is safely in the product.
• Always lock the operator control panel and patient control panel when the patient is unattended.
• Always keep the siderails outside of the oxygen tent.
Note: Do not use siderails as a patient restraint device.
To lower the siderail to the intermediate position, grasp the release handle and rotate the siderail forward until it locks
into the intermediate position (
Figure 15 on page 27 ).
Figure 15: Siderail intermediate position
To lower the siderail to its lowest position, grasp the release handle and rotate the siderail forward ( Figure 16 on page
28 ).
Notes
• You can stow the siderail under the litter when the siderail is at its lowest position.
• Make sure that the siderail is in the lowest position before you raise the siderail directly to the full up position. If you
do not completely lower the siderail, the siderail will lock into the intermediate position when you raise the siderail.