Stryker Power-PRO XT 6500, Руководство по эксплуатации и обслуживанию

Страница: 35 / 172

www.stryker.com 6500-509-001 REV B 35
Return To Table of Contents
Operation Guide
LOADING THE COT INTO A VEHICLE WITH TWO OPERATORS AT THE FOOT END - POWERED METHOD
WARNING
Ensure proper hand placement on hand grips. Hands should be clear of red safety bar pivots while loading and unloading
the cot or whenever changing height position of the cot with two or more operators.
1. Place the cot in a loading position (any position where the load wheels meet the vehicle floor height).
2. Lift the vehicle bumper to the raised position (if equipped).
3. Roll the cot to the open door of the patient compartment.
4. Push the cot forward until the load wheels are on the compartment floor and the safety bar passes the safety hook.
5. For maximum clearance to lift the base, pull the cot back until the safety bar engages the safety hook.
6. Operator 1 − Grasp the cot frame at the foot end.
7. Operator 2 − Verify that the bar engages the safety hook and return to the foot end.
8. Both Operators − Lift the cot together, while Operator 1 presses the retract (–) button until the undercarriage of
the cot retracts fully.
9. Both Operators − Push the cot into the patient compartment, until the cot engages the cot fastener (not included).
HIGH SPEED RETRACT/EXTEND
The cot is equipped with a high-speed retract mode to expedite loading/unloading the cot into and out of a vehicle.
• The undercarriage rapidly retracts toward the highest position once the weight of the cot and patient is off of the
wheels. Press the retract (–) button to actuate the control switch.
• The undercarriage rapidly extends toward the lowest position once the weight of the cot and patient is off of the
wheels. Press the extend (+) button to actuate the control switch.
WARNING
• Whenever the weight of the cot and patient is off of the wheels, the cot will automatically enter the high speed
retract mode if the retract (–) button is pressed.
• Once the weight is off of the ground, the operator(s) must support the load of the patient, cot and any accessories.
Failure to support the load properly may cause injury to the patient or operator.