Stryker MV3 5900, Руководство по обслуживанию

Страница: 27 / 138

To calibrate the angles:
1. Enter the Maintenance menu (page 20).
2. Enter Actuator maintenance (page 21).
3. Highlight C Ca alliib brra atte e a an ng glle ess and press E En ntte err.
4. Raise the product to high height and press E En ntte err.
5. Lower the product to low height and press E En ntte err.
6. Lower the product knee and foot actuators and press E En ntte err.
7. The product screen displays C Co om mp plle ette e and sends you to the angle maintenance menu when calibration is complete.
W Wiid dtth h m ma aiin ntte en na an ncce e
Width maintenance provides access to the following:
• Head State
• Mid State
• Foot State
• Head raw position
• Mid raw position
• Foot raw position
• Calibrate deck widths
• Trim Foot
• Trim Mid
• Trim Head
To access width maintenance:
1. Enter the Maintenance menu (page 20).
2. Highlight W Wiid dtth h m ma aiin ntt.. and press E En ntte err.
C Ca alliib brra atte e d de ecckk w wiid dtth hss
N No otte e -- Make sure that all siderails are in the full up position when you perform this procedure.
To calibrate the deck widths
1. Enter the
Maintenance menu
(page 20).
2. Enter Width maintenance (page 23).
3. Highlight C Ca alliib brra atte e d de ecckk w wiid dtth hss and press E En ntte err.
4. Put all decks to the 36” position and press E En ntte err.
5. Manipulate each siderail and press E En ntte err.
6. Put all decks to the 42” position and press E En ntte err.
7. Manipulate each siderail and press E En ntte err.
8. Put all decks to the 48” position and press E En ntte err.
9. Manipulate each siderail and press E En ntte err.
10. The product screen displays C Co om mp plle ette e and sends you to the width maintenance menu when calibration is complete.
5900-009-002 Rev A.0 23 EN