Maintenance Procedures
Chapter 4
15
4. MAINTENANCE PROCEDURES
Always unplug the bed power cord from the wall outlet when cleaning or servicing the bed.
When working under the bed with the bed in the high position, always place blocks under the
mattress support frame to prevent injury in case the bed-down switch is accidentally pressed.
Only qualified maintenance personnel should perform the procedures detailed in this
maintenance guide. Failure to observe this restriction can result in serious damage to material
and/or severe injury to people.
Use only identical replacement parts provided by Stryker Bertec.
N
N
O
O
T
T
E
E
Except for rare exceptions, reference points - i.e. A, B, C, appearing in sequence of instructions
will refer to a figure immediately preceding this sequence of instructions.
4.1 SIDERAIL ASSEMBLY COMPONENT REPLACEMENT
FOOT SIDERAIL ASSEMBLY
Required Tools:
5/32" Allen Key
Procedure :
1. Raise the bed to the high
position and lock the casters.
2. Lower the head siderails and
raise the foot siderails.
3. Raise the Knee Gatch to the
high position.
4. Unplug the power cord from the
wall receptacle.
5. Manually lift and fold the foot
section back towards the head
end of the bed (see figure 4.1 in
Appendix D).
6. Using a 5/32" Allen key, remove the four bolts/lock washers (
A
) holding the siderail
assembly to the foot section.
The four bolts (A) used to mount the siderail assembly cannot be reused because their Scotch-
Grip coating is less efficient once they have been tightened and removed thereafter. They
must
be replaced with new identical bolts.
7. Lift up the assembly to disengage it from the anchor point (
B
) and remove it.
8. Reverse the above steps to install the replacement foot siderail assembly.
9. Verify the foot siderail for proper operation before returning the bed to service.
W
W
A
A
R
R
N
N
I
I
N
N
G
G
A
B
FOOT SIDERAIL
FOOT SECTION
Figure 4.1A
W
W
A
A
R
R
N
N
I
I
N
N
G
G
Содержание GOBED FL17E
Страница 2: ......
