Stryker Atlas 660Z, Руководство по обслуживанию

Страница: 24 / 104

660 Zoom Stretcher 0660
−
009
−
002 REV E
page 3
−
9
PCB Display Box Assembly Removal
Required Tools:
7/16
”
Socket w/Extension 3/8
”
Drive Ratchet T
−
40 & T
−
27 Torx Sockets
1/2
”
Wrench
1. If the unit is equipped with an IV Pole, remove the nut and bolt holding the IV pole in the socket and remove
the IV pole.
2. Lift straight up on the display cover to separate the Velcro holding it on and remove the cover.
3. Remove the two hex head cap screws holding the belly tray to the underside of the base plate and remove
the tray.
4. Remove the two hex head cap screws and the two hex washer head screws fastening the PCB box as-
sembly to the base plate.
5. Carefully lift up on the PCB box assembly to expose the load cell cable, signal coil cord and left and right
handle connections.
6. Disconnect the cables and lift out the PCB box.
Load Cell Replacement
Required Tools:
7/16
”
Socket w/Extension 3/8
”
Drive Ratchet T
−
40 & T
−
27 Torx Sockets
1/2
”
Wrench 9/16
”
Socket
1. Remove the PCB box assembly to gain access to the load cell (see procedure above).
2. Disconnect the load cell cable at the handle PCB assembly
3. Remove the two hex head cap screws holding the load cell to the base plate.
4. Remove the external retaining ring from the handle cross bar.
5. Slide the handle cross bar from left to right.
6. Remove the load cell.
Zoom Handle Assembly Removal
Required Tools:
Small Phillips Screwdriver
1. Remove the three pan head screws holding the halves of the handle grip together and remove the covers.
2. Carefully pull out the light pipe assembly and disconnect the handle switch cable from the handle exten-
sion cable.
3. Remove the handle pivot pin and external retaining ring securing the handle to the handle pivot.
4. Remove the handle.