Stryker AIR+ 2863, Руководство по обслуживанию

Страница: 7 / 46

A
B
D
C
E
F Fiig gu urre e 1 1 –– B Bu um mp pe errss
4. Using G Go oo off O Offff Household Heavy Duty Remover, a small slotted screwdriver, and towels, remove the adhesive from
the back cover.
5. Using alcohol prep wipes, clean the back cover bumper pad areas and current compliance label (E).
6. Install the new top bumper (A), bottom left bumper (B), and bottom right bumper (C) to the back cover (D).
7. Verify proper operation before you return the product to service.
F Fo oo ott rre ep plla acce em me en ntt
T To oo ollss rre eq qu uiirre ed d::
• T20 Torx driver
• 6 mm socket
• Ratchet
P Prro occe ed du urre e::
1. Unplug the power cord from the wall outlet.
2. Unplug the support surface tubing from the pump.
3. Place the pump face down on a work surface.
4. Using a T20 Torx driver, remove the six screws that secure the back pump housing to the front pump housing. Save the
screws.
5. Using two hands, rotate the pump assembly to the right so the front is on your left.
6. Separate the front and back pump housing. Place the back pump housing down on the work surface.
7. Using a ratchet and a 6 mm socket, remove the six nuts that secure the foot to the front pump housing. Save the nuts.
8. Remove and discard the foot.
9. Reverse the steps to reinstall ( Pump housing rubber foot assembly - 2874-007-022 (page 25)).
10. Verify proper operation before you return the product to service.
2863-009-002 Rev AA.1 5 EN