Installation Instructions
3
INSTALLING THE INFANT WARMER CARE STATION LIGHT
Required Tools:
Drill with 3/32” Bit
Phillips Screwdriver
Standard Screwdriver
6mm Allen Wrench
Procedure:
1. If the Infant Warmer being worked on was ordered with a light, and has pilot holes already installed, omit
step two.
2. Facing the front of the Infant Warmer, the light must be mounted on the left side (opposite the control pan-
el). Using the drill and the 3/32” bit, drill four pilot holes as shown in diagram B.
WARNING
Mount the light only in the specified location.
3. Install the light mount as shown in diagram D, using the four 1 1/4” screws supplied in the kit. The light
pivot screw should face the front of the unit.
4. Push the light base stud into the mount and tighten the pivot screw, using either a standard screwdriver
or a 6mm Allen wrench.
5. Affix the warning labels to the plastic diffuser tray as shown in diagram A.
6. Using the dimensions in diagram C, drill two pilot holes for the cord cleat. Install the cleat with the screws
supplied in the kit.