Stryker 6516, Руководство по эксплуатации

Страница: 39 / 70

A
B
C
C
F Fiig gu urre e 1 16 6 –– D Drra ag ge err® ® iin nccu ub ba atto orr
F Fiig gu urre e 1 17 7 –– U Un nllo occkke ed d p po ossiittiio on n
F Fiig gu urre e 1 18 8 –– L Lo occkke ed d p po ossiittiio on n
IIn nsstta alllliin ng g tth he e A Aiirrb bo orrn ne e iin nffa an ntt ttrra an nssp po orrtt iin nccu ub ba atto orr a ad da ap ptto orr iin n tth he e sstta acckka ab blle e
cco on nffiig gu urra attiio on n
W WA AR RN NIIN NG G
• Do not install these incubator adaptors on any other Stryker cot or on any cot from another manufacturer. These
incubator adaptors are for use only on the P Po ow we err--P PR RO O IT cot.
• Always make sure that the incubator adaptor is properly installed on the cot and the incubator is securely fastened to the
incubator adaptor before use.
Before you install an incubator adaptor on the P Po ow we err--P PR RO O IT cot, read and understand this manual and the manual that
was supplied with the incubator adaptor.
To install the incubator adaptor:
1. Using a 1/2" socket and ratchet, remove the four 5/16" hex nuts and washers (A) from the mounting studs (B) on the
incubator adaptor (Figure 41). Save the nuts and washers.
2. Locate the mounting holes in the bottom of the oxygen bottle module (C).
3. Install the oxygen bottle holder on the incubator adaptor mounting studs (B) with the bottle openings facing toward the
retractable head section. Place all four mounting studs into the mounting holes of the oxygen bottle holder.
6516-209-001 Rev D.0 35 EN