Stryker 2920, Руководство по эксплуатации

Страница: 13 / 42

www.stryker.com 2920-109-001 REV G 9
Installation
This section explains how to install the support surface and the control box. The support surface is either equipped with
a standalone pendant control option or integrated with
InTouch FL27 Critical Care Bed option. The differences are
noted in the appropriate installation steps.
1. Position the support surface onto the bed.
2. Flip the foot section toward the head end.
3. Turn the control box upside down and place the control box into the opening in the foot section of the support
surface (
Figure 2 on page 9 ).
Figure 2: Insert the foot box
4. Match the outer transparent tubes colors to the manifold colors and connect them ( Figure 3 on page 9 ) (Green,
Blue, Red, White, Black Yellow).
Figure 3: Connect tubes by color
5. Connect the tilt sensor cables.
a. Align the white dots on the tilt sensor cable connectors.
b. Twist the tilt sensor cables clockwise to fasten ( Figure 4 on page 10 ).