Stryker 2100, Руководство по обслуживанию

Страница: 20 / 63

Service Information
17
MANIFOLD REPLACEMENT
MANIFOLD KIT #88–0316–12–00
Required Tools:
Phillips Screwdriver 3/8” Nut Driver
SIde (Wire) Cutter
Replacement Procedure:
1. Raise bed to the full up position then lower about 2” to gain access to lower manifold screw.
CAUTION
Disconnect power plug from wall receptacle.
2. Remove headboard, foot mattress, foot extension, foot pans, I.V. pole and leg supports.
3. Set brake with casters turned as though the bed is being pushed backwards. The casters at the head end
of the bed must be five feet away from the wall.
4. With the assistance of another person, lift the foot end of the bed chassis and rotate the locked rear casters
until the upper frame–headboard mounts touch the floor.
5. Disconnect the manifold electrical connectors at the control box.
6. Remove the two manifold mounting screws, washers and cable clamps.
7. Cut and remove air lines to the seat–left, seat–right and lumbar at the manifold fittings and cut air lines at
compressor.
8. Connect the air lines to the replacement manifold fittings.
9. Mount the manifold to the litter with the two star lock washers and screws.
10. Reconnect the electrical plugs to the control box and replace the cable clamps.
11. Be sure all screws, cables and electrical connections are secure.
12. With the assistance of another person, tilt the bed back down to the floor.
13. Plug the power cord into the wall receptacle. Run through all functions on the hand pendant at least three
times to ensure proper operation. Check for proper cable routing and attachment to prevent interference.
14. Check electrical safety in conformance with specified hospital requirements (leakage current, ground conti-
nuity, etc.)
15. Remount all items removed in step two and return bed to service.