Stryker Medical Thermaltek 1030, Руководство по обслуживанию

Страница: 23 / 116

Service Information
18
WARMER HOSE REPLACEMENT
Hose p/n 1030–35–42 (18”) and 1030–35–45 (37”)
NOTE
Refer to assembly drawing 1030–426–10, modular warmer assembly (page 66) for part reference.
1. Grasp the hose fitting (W) and carefully pull downward to disconnect the hose from the foot section and
the float manifold.
2. Turn hose fittings (W) clockwise to remove from both ends of the heater hose (X or Y).
3. Install replacement hose by reversing the above steps
OUTLET ADAPTOR REPLACEMENT
Required Tools:
Drill and 3/16” Bit 3/8” Wrench 1/8” Hex Allen Wrench
NOTE
Refer to assembly drawing 1030–234–10, modular warmer outlet assembly (page 70) for part reference.
Replacement Procedure:
1. Raise the litter to the full up position and remove the mattress.
2. Grasp the hose fitting and carefully pull downward to remove the flexible hose from the bottom of the outlet
adaptor needing to be replaced.
3. Drill out the four rivets (item N, page 70) holding the outlet adaptor. Using a 3/8” wrench and 1/8” hex Allen
wrench, remove the two cap screws, nuts and washers ( items L and H or J, or K, M and F on the foot
end, page 70) on the outlet adaptor.
4. Reverse the above steps to install the new adaptor.