23
CLEANING SCHEDULE (PERFORMED BY STORE PERSONNEL) D = Daily / W = Weekly / M = Monthly
Area
D
W M
Task
Exterior
X
Side glass, front curved glass and sliding rear doors:
Clean with household or
commercial glass cleaner and soft cloth.
X
Wood, laminate and painted surfaces:
Clean with a warm soap and water solution and soft cloth.
Never use wire cloth or abrasive cleaners on case.
X
Rear door (if any):
Clean with a household or commercial glass cleaner.
X
Removable, magnetized condenser coil filter:
Clean magnetic condenser coil filter by following either of these steps:
1. As magnetic condenser coil filter is dishwasher safe, remove from case
and use a rag or soft-bristled brush to wipe off excess dust particles from
filter. Run in normal dishwasher cycle. Remove from dishwasher. Dry with
soft cloth or paper towel. Return to case.
2. If not using dishwasher, remove magnetic condenser coil filter from case.
Use a rag or soft-bristled brush to wipe off excess dust particles from filter.
Submerse in warm, soapy water. Use soft-bristled brush to remove dust,
dirt, grease and grime that may collect on filter. Rinse thoroughly.
3. Dry with soft cloth or paper towel (as shown below) or allow to air dry.
Return to case.
Interior
X
Decking:
Wipe down with a warm soap and water solution and soft cloth.
X
Interior components (rear plenum, sides, stainless steel mirror, etc.):
Wipe
down with a warm soap and water solution and soft cloth.
X
Acrylic air deflector (front) / perforated Plexi-glas plenum (rear):
Clean with soap and water solution and soft cloth.
Never use ammonia-based cleaners on acrylic or Plexi-glas.
X
Decking:
Remove decking and clean with soap and water solution and soft cloth.
For stubborn stains, submerse in warm, soapy water and allow to soak.
Use soft-bristled brush to remove residue.
X
Units with risers (“step assemblies”) only:
Remove from case and clean with mild soap and warm water solution and
brush. Dry thoroughly and return to case.
For stubborn stains, submerse in warm, soapy water and allow to soak. Use
soft-bristled brush to remove residue.
Caution! Remove (and return) risers carefully to avoid marring inside of case.
X
Acrylic bin doors and door assembly (not on all cases):
Clean with a warm soap and water solution and soft cloth.
Do not use glass cleaner on acrylic as it causes surface to become ‘cloudy’.
To clean acrylic bins doors (and surrounding areas) more thoroughly, rotate
keys (at upper assembly areas); lower levers holding it intact. Lift assembly
up and off pins holding lower acrylic bin door assembly bracket to deck.
Thoroughly clean upper glass enclosure (while door assembly is removed).
Rinse any soap/water residue from acrylic bins and/or assembly. Dry. Return
to upper glass enclosure in reverse order it was removed. Lock in place.
Important! Store keys in safe but accessible location for ready access.
