8
INSTALLATION: ADJUSTING LEVELERS / WIRING DIAGRAMS / FIELD WIRING CONNECTIONS
9. Cases With Levelers: Adjust Levelers
After case is in position, adjust case so it is level
and plumb (see illustration at right).
You may need to remove front and/or rear Toe
-Kick to access levelers.
Use adjustable wrench (and possibly a pry bar)
to adjust leveler.
Do not use pry bar on toe-kick (it may buckle).
Do not use pry bar on end panel (it may chip).
Use pry bar ONLY on base frame to avoid
damaging case.
Use block to reach base frames with pry bar.
See illustrations at right.
10. Wiring Diagram
Each case has its own wiring diagram folded and
in its own packet.
Wiring diagram placement may vary; it may be
placed near condenser fan cover, ballast box,
raceway cover, or other related location.
11. Field Wiring Connections (HMG3953)
Caution! Wiring process must be performed by
certified electricians only.
Remove ballast box face (by removing screws).
Remove screws from inner support.
Knockouts are located on side and rear of box for
making electrical connections.
Several ballast locations (depending upon model)
are shown in illustrations on this sheet.
Serial label (at case rear) lists voltage rating.
See next page for field wiring connections to
other models.
Pry Bar
Base
Frame
Leveler
Adjustable
Wrench
Toe-Kick
Block
Ballasts
Field wiring
connection /
junction box
