Page 6 of 12
warehouse barn light was designed.
Do not use any harsh abrasives, detergents or anything containing ammonia to clean your light.
Risk of fire. Install fixture at least 4 feet from the ground.
Risk of electric shock. Disconnect power before servicing.
This product must be installed in accordance with the applicable installation code by a person
familiar with the construction and operation of the product and the hazards involved.
Keep protective barrier in place or replace removable parts after servicing.
Blinking light of this thermally protected luminaire may indicate overheating.
Ensure the fixture is properly grounded.
Main Parts of Barn Light
Reference Number
Subassembly
1
Shade
2
Cage
3
Gooseneck
Assembly Instructions
⚠
WARNING
Disconnect power at main electrical box before installing fixture.
1.
Disconnect power at main electrical box before installing fixture.
2.
Run black and white wires from connect nipple (7), gooseneck (8), back plate (9), gasket (10),
and driver box (11).
3.
Rotate the connect nipple (7) to the hex connector (6). Rotate gooseneck
（
8
）
to the other end
of connect nipple (7). Seat other end of gooseneck into the back plate (9). Then
rotate set
screws
（
15
）
in back plate to place the gooseneck.
Attach back plate to the driver box (11) by
M4x12 screw (16).
Note: wrap each of the threads with PTFE thread seal tape (20).
4.
Attach the black fixture
wire to “-” wire of driver (12) and the white fixture wire to “+” wire of driver
(12), using wire nuts (25) provided.
5.
Attach the
“N” wire of driver (12) to the neutral wire and the “L” wire of driver (12) to the live wire
using wire nuts (25) provided.
6.
Connect green wire to grounding screw in the junction box.
7.
Attach the driver box (11) back to junction box by #8-32 screws (14). (You can also use tapping
screws
（
21
）
and wall plugs
（
22
）
for attaching.)
Additional Instruction for Gooseneck with Knuckle Mounting
1.
Disconnect power at main electrical box before installing fixture.
2.
Run black and white wires from knuckle (18), gooseneck (8), back plate (9), gasket (10) and
driver box (11).
Note: Before crossing the wire, foist the cotton varnished sleeve (23) into the knuckle to protect the
wire. Refer to the figure for wiring through knuckle.
