Page 11 of 15
TO STOP THE FAN OSCILLATION:
To stop the oscillation of the fan, push CONTROL POST
downward till it clicks into place. (See arrow in Figure 2.)
SPEED CONTROL:
Select air speed by setting switch to either HIGH, LOW, or OFF.
IMPORTANT:
It is normal for the motor to feel warm to the touch after continuous operation. This fan
features a thermostat that will automatically shut off should it overheat for any reason. If this happens,
immediately unplug the fan from the outlet. Wait approximately 15 minutes before plugging back in.
After Each Use
⚠
WARNING
Be sure fan speed control is in the OFF position.
Maintenance
⚠
WARNING
UNPLUG FROM ELECTRICAL SUPPLY BEFORE CLEANING.
Maintain your fan.
It is recommended that the general condition of any fan be examined before it is
used. Keep your fan in good repair by adopting a program of conscientious repair and maintenance.
Have necessary repairs made by qualified service personnel.
Lubrication.
Apply a small amount of lubricant oil into bearing room of the shaft (#7) by the hole of
the motor (#8). If fan is used continuously, this should be done every three months. If fan does not run
continuously, lubrication should take place once every six months.
Cleaning:
1. Use a soft, damp cloth (water only) for cleaning, then wipe with dry cloth.
2. Do not use cleaners that harm paints or plastics; i.e., bleach or ammonia.
3. Do not bend blades.
Troubleshooting
Failure
Possible Cause
Corrective Action
FAN STOPS
RUNNING
Surges in electrical power or excessive
heat
UNPLUG from power source. Wait
approximately 15 minutes for the fan to
resume operation.