Strongline MEG1000i, Инструкция по эксплуатации

Страница: 82 / 84

81
Troubleshooting cont.
DC circuit
breaker
continually
tripping
1. Overload 1. Reduce load.
2. Faulty cords or equipment 2. Check for damaged, bare, or frayed wires on
equipment. Replace.
3. Incorrect cables used 3. Check to make sure you are using the DC cables
supplied with the actual generator. Using the incorrect
cables could result in the crossing over of polarity. Only
use the supplied DC cables with the actual generator.
4. Mixed polarity 4. Check to make sure that the DC cables are connected
to the correct battery polarity terminals. That is positive
(+) to positive (+) and negative (-) to negative (-).
Generator
overheating
1. Generator overloaded 1. Reduce load.
2. Insufficient ventilation 2. Move to adequate supply of fresh air.
Generator
stops
1. Generator may have fallen over 1. Check to make sure that the generator is in it’s correct
upright position. If not take corrective action to put it in the
upright position.
2. Generator may have ran out of oil 2. Check to make sure that the generator has oil in it. If
not take corrective action to top up the oil tank.
3. Generator may have ran out of Fuel 3. Check to make sure that the generator has fuel in it. If
not take corrective action to top up the fuel tank.