Strongline MEG1000i, Инструкция по эксплуатации

Страница: 68 / 84

WARNING. Prior to connecting any appliance to the generator, check the rating label of the appliance. The generator is
rated at 850W so if the appliance being connected is higher than
to prevent over load damage to the generator. The generator will withstand short operation up to
20 minutes.
Note. Motorized products will require more energy upon start up and products, which are rated below
if the starting current is excessive, this is not due to a performance fault of the generator.
22
、 、 、 、
DC Applications
The DC output should only be used for recharging 12
while they are connected to a vehicle. Make sure they have bee
for recharging.
Note. Only use the DC leads provided with this
generator, when using the DC output.
When charging a battery the following instructions need to
be followed:
1. Disconnect the original leads from the battery.
2. Fully loosen the battery fluid filler caps.
3. Fill the battery cells with distilled water to the upper limit if
the battery is empty.
4. Measure the specific gravity fluid by using a hydrometer
and calculate the charging time in accordance with the
table shown (Fig.P).
5. For a fully charged battery, the specific gravity range shall
be within 1.26 to 1.28. It is recommended to be checked
and confirmed every hour.
67
Prior to connecting any appliance to the generator, check the rating label of the appliance. The generator is
0W so if the appliance being connected is higher than 850W, the protective cut out may switch the generator off
event over load damage to the generator. The generator will withstand short operation up to 1050W for a maximum of
Motorized products will require more energy upon start up and products, which are rated below 850W, may not start
arting current is excessive, this is not due to a performance fault of the generator.
The DC output should only be used for recharging 12-volt automotive lead acid type batteries, and do not charge batteries
while they are connected to a vehicle. Make sure they have been totally disconnected prior to connecting to the generator
Note. Only use the DC leads provided with this
When charging a battery the following instructions need to
3. Fill the battery cells with distilled water to the upper limit if
4. Measure the specific gravity fluid by using a hydrometer
in accordance with the
5. For a fully charged battery, the specific gravity range shall
be within 1.26 to 1.28. It is recommended to be checked
O
Prior to connecting any appliance to the generator, check the rating label of the appliance. The generator is
0W, the protective cut out may switch the generator off
W for a maximum of
0W, may not start
volt automotive lead acid type batteries, and do not charge batteries
n totally disconnected prior to connecting to the generator