Strong XENON SUPER TROUPER, Инструкция по эксплуатации

Страница: 21 / 58

MAINTENANCE
THE XENON SUPER TROUPER SPOTLIGHT requires very little maintenance to
keep it in good working order.
THE REFLECTOR should be cleaned periodically with a clean, soft, lint free cloth to
remove any dust from the reflective surface. Do not use abrasive cleaners.
CHECK ALL ELECTRICAL CONNECTIONS periodically for tightness, especially
the bulb connections and other leads in the DC circuit.
THE XENON LAMPHOUSE requires no lubrication other than the blower motor.
This should be lubricated with two or three drops of non-detergent oil at each oil hole every six
months. The lamphouse cover must be removed to expose the oil holes.
THE XENON BULB should be checked occasionally for presence of foreign material
on the envelope. Any dirt or other foreign material must be removed immediately. CAUTION:
Observe all safety procedures when working around the exposed bulb.
THE INSIDE OF THE LAMPHOUSE and the blower should be cleaned periodically,
depending on the dust conditions at each installation. The blower requires cleaning to remove dust
build up which accumulates over a period of time. Keep the air inlet grille clean to permit free air flow.
THE OPTICAL SYSTEM LENSES must be kept clean to prevent any light reduction
in the projected spot. To gain access to the lenses, tighten the horizontal swing and vertical tilt locking
clamps, and remove the color boomerang and optical system housing.
CLEAN THE PROJECTION LENS and large lens with any cleaner approved for use
on coated projection lenses. If the small lens is removed for cleaning, the end of the lens with the FL
marking ring must be toward the iris when replaced in its support.
WHEN TRANSPORTING the spotlight, it is recommended that the xenon bulb be
removed and placed in its original shipping carton with the cover on to insure against breakage. If the
spotlight is equipped with a bulb shock mount, the unit may be transported with the bulb installed,
assuming reasonable caution is exercised. Under
no circumstances should the unit be moved until the
bulb has cooled to room temperature.
XST/019