Strong XENON SUPER TROUPER, Инструкция по эксплуатации

Страница: 17 / 58

Once the “hot spot” is centered in the projected spot, lock the adjustment control in position with the
two thumb screws and rotate the focus control to obtain a spot with an even distribution of light. Turn
the spot focus control knob at the front of the lens mechanism to sharpen the edge of the spot.
THIS ADJUSTMENT should not be disturbed until the xenon bulb is replaced. At this
time it will be necessary to repeat the alignment procedure.
REPLACE THE REAR COVER PANEL over the bulb adjustment control mecha-
nism. Secure using the plastic fasteners.
BECAUSE OF MANUFACTURING TOLERANCES and normal bulb aging, it may
be necessary to operate one lamp at slightly higher or lower current than others to obtain equal light
balance between units. These adjustments are made at the xenon power supply.
TO EXTINGUISH THE ARC, place the LAMP switch in the OFF position. The
blower in the lamphouse will continue running until the xenon power supply is de-energized. Allow
the blower to operate and cool the bulb for
at least five minutes after extinguishing. This measure will
prolong bulb life.
TO OPERATE THE SPOTLIGHT from a remote location or an automation con-
troller, the lamphouse must be equipped with the MODE (Auto-Man.) switch. With the MODE
switch in the “AUTO” position, and the LAMP switch “ON,” the lamphouse will ignite by means of
a dry contact across terminals 3 and 6 at the lamphouse or power supply (See Lamphouse-Power
Supply Interconnection Diagram). This type of installation is intended for use
only if the spotlight is
“locked down” as a fixed spot without an operator at the unit.
XST/015