Strong SRT 8903, Руководство пользователя

Страница: 12 / 27

9
PART 2 • English
En
gl
is
h
When all settings have been made, move the highlight to OK and press ok to continue.
noTE:
Wrong region selection can lead to missing channels or channels being
stored on wrong positions in the channel list.
The receiver will now advance to the Aerial Adjustment screen.
This part of the installation wizard is of great help when setting up your antenna system.
Use
pq
to move the highlight to the setting you wish to alter and use
tu
to change values. The
following settings are available:
Antenna Power:
Set to On if you use an active antenna. When set to On, 5 V will be present on
the ANT IN connector of the receiver. Select Off for passive antennas.
Beeper: Select On for an audible indication of signal reception. Off turns the beeper
off.
Channel No.: Select a channel that is known to carry a broadcast in your region. The Signal
Strength and Signal Quality bars give a visual indication of the reception.
Adjust your antenna to obtain maximum signal strength and quality.
When all settings have been made, press ok to start scanning.
The receiver will now search for all available channels. When the scanning is finished, the receiver
switches to viewing mode.
TIP:
If the Welcome “Easy install” menu does not appear after switching on the
receiver the first time, reset the receiver to the factory settings by pressing
the mEnu button and selecting Load Factory Setting in the submenu Tools.
(Default PIN 1234)
5.0 QuICk guIdE To usIng YouR RECEIvER
We at STRONG understand that you can’t wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will make you familiar with the basic operation of this device. We
do, however, advice you to read the full manual to get the best performance from your receiver.
To turn your receiver ON or to standby, use the
q
button on the remote control.
Choose a channel with the
pq
buttons. You can also digit the channel number with the 0~9 buttons
on the remote control or press ok in viewing mode to display the channel list. The volume can be
adjusted with the
tu
buttons.
If you have a Conax smartcard from your provider, please insert it into the CA slot on the right hand
side of the receiver, behind the flap. Insert the card with the chip side down.
6.0 oPERATIon
Your new receiver is equipped with several features to make watching TV a true pleasure. This paragraph
describes these features. Please also read chapter 7.0 to get familiar with the menu of your receiver.
6.1 Changing channels
Your new receiver is equipped with four ways to change channels.
„ „
Via direct access using the 0~9 buttons.
„ „
Via the channel list through the ok button.
„ „
Via the Pg+ and Pg- buttons.
„ „
Via the
pq
+ ok buttons.