Strong SRT 8119, Руководство пользователя

Страница: 23 / 29

English
The picture and sound
remain frozen, or macro
blocks or similar distortion
are visible on the screen.
The transmission signals are
too weak or have reflections/
interference.
The antenna is not properly
adjusted.
Press the INFO key on the remote
control 3x to call up signal bars to
visually assess signal strength and
signal quality (both parameters
should be visible in the last third
of the infobars). Contact your local
Service.
No sound on TV or
amplifier.
The volume of the TV is set
too low.
The volume of the receiver is
set too low.
Increase the volume of the TV with
its remote control.
Increase the volume of the receiver
with its remote control.
The correct input is not
selected on your TV or
amplifier, or the unit is set
to a higher resolution than
supported by the TV.
Switch to the correct TV/amplifier
input.
Select lower resolution on the
receiver.
The TV, digital receiver or
amplifier is not switched on.
Switch the TV/digital receiver/
amplifier on.
The TV or digital receiver is
not connected to the mains.
Check the mains lead.
Bad cable connection.
Make sure that any existing digital
or analogue A/V cable connections
between the used equipment (TV,
digital receiver, or A/V amplifier) are
properly connected.
Audio is muted.
Press the
!
button on your remote
control.
The TV power is off. Turn the TV on.
No access to scrambled
services.
The channel is scrambled.
Your receiver does not
support scrambled channels.
Select an alternative channel.
19