Strong International SUPER TROUPER II, Инструкция по эксплуатации

Страница: 13 / 52

BULB ALIGNMENT & LAMPHOUSE OPERATION
PRIOR TO OPERATING THE SPOTLIGHT, verify the following conditions:
• The plastic protective cover has been removed from the xenon bulb.
• The strip heat filter is installed with the coated surface facing the bulb .
• The lamphouse access cover is in place and secured using all (3) screws.
SEE THE PRECEDING “BULB INSTALLATION” SECTION for instructions detailing the
above. Failure to remove the plastic bulb cover will damage or destroy the xenon bulb. A missing or reversed
heat filter will cause damage to the lens system. The lamphouse cover must be installed correctly and secured
to actuate the interlock switches and permit lamp ignition.
ENERGIZE THE XENON POWER SUPPLY by switching the circuit breaker on the side
panel ON. The red light adjacent to the circuit breaker will glow, indicating that the power supply is ready for
operation. The lamphouse blowers will start and actuate the blower interlock switch to permit bulb ignition.
The lamp blowers will operate continuously until the xenon power supply is de-energized. Place the lamphouse
MODE switch in the “MAN.” (manual) position. This is the normal setting for the MODE switch, as it permits
ignition control of the spotlight at the unit, and not from a remote location. REMOTE/AUTO operation is
outlined in the section following, and illustrated on the Lamphouse-Power Supply Interconnection Diagram.
PLACE THE LAMP SWITCH in the ON position and the bulb will ignite. Allow a few
minutes for the current to stabilize, and read the lamphouse ammeter. The bulb must be operated within the
current range specified by the bulb manufacturer. The ranges for the xenon bulb supplied are as follow:
Nominal DO NOT
Wattage Current EXCEED
1000 50 A. 58 A.
1600 65 A. 70 A.
2000 75 A. 90 A.
ADJUST THE XENON POWER SUPPLY as instructed in the power supply manual for the
correct operating current. A new xenon bulb is normally operated at “nominal” current. After prolonged use,
the light output will decrease because of normal bulb aging. At this time, the current output setting may
periodically be increased to compensate for bulb aging, but do not , at any time, exceed the maximum current
level specified.
DISMOUNT THE COVER PLATE located above the lamphouse instrument panel by
removing the three black phillips head screws and finish washers. This exposes the control mechanism for
adjusting the position of the xenon bulb.
THE CENTER SECTION of the control is a threaded member that focuses the bulb in relation
to the reflector. Turning this adjustment moves the bulb on the horizontal plane, into or out of the reflector.
Rotating this section clockwise moves the bulb away from the reflector. The small knurled screw to the left of
this section can be tightened to lock the focusing mechanism in place after the bulb alignment procedure has
been completed.
ST2/011