3 Transport and storage
3.1
Transport
NOTE
Be particularly careful when transporting the GTES in order to avoid damage caused by external
forces or careless loading and unloading. Depending on the type and duration of the transportation,
corresponding transportation locks have been provided. Remove the transport lock only when begin-
ning assembly, see section 6.3.
The information marked on the packing pieces must be observed.
During transportation, avoid:
► water condensation resulting from severe temperature fluctuations
► impacts
3.1.1
Unpacking
The transportation route is decisive in terms of the type of packing. The information marked on the packing
pieces must be observed.
RECYCLING
Dispose of the packaging material according to the local guidelines properly and in an environmental-
ly-friendly way.
3.2
Scope of delivery
On receipt, check the delivery for completeness using the packing list. Possible damage during transportation
and/or missing parts must be reported immediately, see section 11.2 for the address.
3.2.1
Pre-mounting condition
The GTES is supplied assembled and ready for operation, and is prepared for direct assembly in the machine.
NOTICE
Damage to the machine due to the incorrect adjustment of the GTES
When the GTES has not been adjusted, traverse movements of the machine can lead to damage.
► Before commissioning the machine, always adjust the GTES first in accordance with the specifica-
tions in the mounting/operating instructions.
9
Mounting/operating instructions Gear limit switch Type series HGE • No. 152-00000 F • 10/2017
