O P E R AT I O N
Once the system has been plumbed and wired in accordance with this manual it is time to switch the mains
supply on.
When power is supplied to the unit the indicator light will illuminate to show that the system is ready, and
begining to heat the water.
The dial on the outside of the case can be used to control the temperature that the internal water store
is heated to, turning this higher will increase the store temperature, turning it lower will decrease it. We
recommend adjusting the thermostat over a few days until the desired temperature is achieved. Remember
to only run the heater at the temperature required to avoid wasting energy.
In the event of overheating there is a safety cut out stat built into the unit. This has a resettable switch that
can be pressed to reset and can be found on the immersion heater inside the unit. We recommend that you
have a proper engineer service the unit and this is not attempted by the user.
The immersion heater is located below the grey plate on the underneath of the unit. If the unit has been
installed so this plate is inaccessible please disconnect the unit from the mains, isolate the water supply,
drain down, and remove the unit from the wall for maintenance.
Before attempting to maintain the unit please ensure you have isolated the electrical supply.
M A I N T E N A N C E
Before attempting to maintain the unit please ensure you have isolated the electrical supply, and should
only be performed by a qualified professional.
This unit is a mains pressure hot water unit, and it is recommended that this device be serviced annually
to ensure a long and healthy lifespan.
Your water heater includes a Magnesium sacrificial annode as part of the immersion heater assembly. The
annode is present to ensure that your water heater does not corrode, should this device not be serviced,
the tank may corrode. The location of the immersion is as described above and is accesible from the grey
service hatch on the bottom of the unit.
The annode should be inspected annually and the condition checked, if the annode is sufficiently corroded
it should be replaced to ensure the protection of your water heater.
Additionally the pressure relief valve should be inspected annually, as well as the expansion vessel, check
valve, and pressure reducing set if fitted.
G U A R A N T E E
Your
Strom-Electrical
water heater is guaranteed for a period of 12 months from the date of purchase.
The unit is only guaranteed if the water heater has been installed and maintained in accordance with these
instructions. Full guarantee information can be found at:
www.strom-electrical.com/guarantee
6.
