General Technical Description
3 — 16
02_0465_0802GB
Further elements have been installed on the machine for operation
and control.
1
2
3
Different models available
Item
Designation
1
”Working pressure” gauge
2
”Working pressure” handwheel
3
”Tank pressure” gauge
The working pressure is displayed on the ”working pressure”
gauge (1).
The tank pressure is displayed on the ”tank pressure” gauge (3).
The compressor switches off automatically on reaching the cut-out
pressure threshold. The compressor switches on again automatically
when the tank pressure falls below the start-up pressure.
Refer to the chapter: ”General Technical Description” -- section:
”Technical data” for information on the cut-out and start-up pressure
of the compressor.
The working pressure is adjusted using the ”working pressure”
handwheel (2).
Preset the correct working pressure for the pneumatic tool in
question. The compressed air output depends on the preset working
pressure.
The higher the working pressure, the larger the amount of
compressed air supplied.
Caution
Read the information provided by the manufacturer before
connecting ”pneumatic tool” accessories.
The maximum values must not be exceeded!
3.11 Operating elements
