Press < > button again to
3
confirm the setting. Then
your
FEC
and
FEB
settings
are displayed on the LCD
panel.
Set the exposure bracketing
2
amount. Turn the Select Dial to
set the amount.
FEL: Flash Exposure Lock
FEL
can lock the correct flash exposure setting for any part of the
scene.
With <
ETTL
> displayed on the LCD panel, press the camera’s
<
FEL
> button. If the camera does not have the <
FEL
> button, press
the <
*
> button.
●
FEB will be cancelled after three photos are taken.
For best results, set the camera drive mode to “single” and
ensure the flash is ready before shooting.
FEB can be used with FEC and FEL.
You can prevent the FEB from being cancelled
automatically after three photos are taken. (C.Fn-03 ,
see P22)
The FEB shooting sequence can be changed. (C.Fn-
04, see P22)
●
●
Focus the subject.
1
Press the <
FEL
> button.
2
Aim the subject at the center of
the viewfinder and press <
FEL
>
button.
The camera flash will fire a
preflash and the required flash
output for the subject is retained
in memory.
Each time the <
FEL
> button is
pressed, a preflash will be fired
and a new flash exposure
setting will be locked.
●
●
●
●
If the subject is too far away and
underexposed
, the < >
icon will blink in the viewfinder. Move closer to the subject
and try the FE lock again.
●
If <
ETTL
> is not displayed on the LCD panel, FE lock
cannot be set.
●
If the subject is too small, FE lock might not be very
effective.
●
If you set a shutter speed that is the same as or slower than
the camera’s maximum flash sync speed, < > will not be
displayed in the viewfinder.
●
With high-speed sync, the faster the shutter speed, the
shorter the effective flash range.
●
To return to normal flash, press < > button again. Then
< > will disappear.
●
Multi flash mode cannot be set in high-speed sync mode.
●
Over-temperature protection may be activated after 15
consecutive high-speed sync flashes.
High-Speed Sync
High Speed Sync (FP flash) enables the flash to synchronize with
all camera shutter speeds. This is convenient when you want to
use aperture priority for fill-flash portraits.
Select < >.
●
Press < > button so that
< > is displayed.
●
Check that < > is
displayed in the viewfinder.
Second-Curtain Sync
With a slow shutter speed, you can create a light train following the
subject. The flash fires right before the shutter closes.
Press < > button so that
< > is displayed on the LCD
panel.
The flash output is adjustable from 1/1 full power to 1/128th power
in 1/3rd stop increments. To obtain a correct flash exposure, use a
hand-held flash meter to determine the required flash output.
Press < > button so that
1
<
M
> is displayed.
Turn the Select Dial to choose
2
a desired flash output amount.
M: Manual Flash
- 11 -
- 12 -
C.Fn
C.Fn
Содержание Pro-Flash Tli-C
Страница 1: ......
