10
R&E Stricker Reha-Entwicklungen GmbH
Additional operating instructions Neodrives
Repair, cleaning and maintenance
8.3 Akku
Never use benzene, thinner, acetone or similar
agents for any cleaning processes. Instead, use
only commercially available household cleaning
agents and disinfectants (isopropanol).
The plug of the charging cable on the charger [9],
the plug of the motor cable [7] and the charging
socket [3] on the battery may only be cleaned with
a dry cloth.
The battery must never be sprayed with a steam jet
or similar.
8.4 Motor
The drive wheel of your hand bike can be removed
from the bike frame at any time, for example for
cleaning purposes or in case of a flat tire. Proceed
with extreme care during this process and during
subsequent assembly and, in particular, also
observe the instructions and information provided
by the manufacturers of the various components
attached to the wheel, especially the brake disc.
NOTE
For reasons of clarity, only the drive motor
integrated in the wheel is shown in the following
graphics, but not the complete drive wheel.
8.5 Removing the drive wheel
Before removing the drive wheel, note or memorize
the cable routing as well as the fastening points
of the cable ties. First loosen and remove all cable
ties with which the cable [16] coming from the
motor as well as cables and supply lines of other
components are fastened to the bicycle frame.
Then disconnect the plug [15] on the motor cable
[16] from the socket [17] on the battery cable.
Loosen the two nuts [18] or the quick release with
which the wheel is attached to the frame so that
the complete wheel can be removed from the
).
Fig. 11: Cable connection to wheel hub motor
NOTE
Note or mark the position of the torque arm
[20] . When attaching the wheel later, it must be
attached in exactly the same position as before
removal. (
WARNING
Never hold or transport the removed wheel by the
cable coming from the motor [16]! There is a risk
of cable breakage.