Stricker Neodrives, Дополнительные инструкции по эксплуатации, Страница: 13 / 20

R&E Stricker Reha-Entwicklungen GmbH
11
Additional operating instructions Neodrives
Repair, cleaning and maintenance
Fig. 12: Do not carry motor by cable
8.6 Attaching the drive wheel
Make sure that all components attached to the
wheel have been mounted according to the
instructions and specifications of the respective
manufacturer. This applies in particular to the
brake and the gear shift. Do not forget to remount
the torque arm [20] in the same position in which it
was previously removed. Then push the wheel into
the receptacle of the frame and tighten it with the
axle nut [18] in the following order:
• first tighten on the side of the gear shift ( Fig.
13 )
• then tighten on the brake side ( Fig. 14 )
The tightening torque of both nuts is between 30
and 40 Nm. Also make sure that the ratchet washer
[19] is under the axle nut, otherwise there is a risk
that the axle nut [18] will come loose.
Fig. 13: Fastening to the fork [1]
Fig. 14: Attachment to the fork [2] and torque arm
If your wheels are equipped with quick-releases,
please observe the manufacturer‘s specifications
for mounting and tightening torque.