28
METHOD OF USE
The display screen will light up and the Battery Charger will enter the standby mode after a 3-5
seconds delay when connected to the power source.
The LCD digital screen will start flashing after the Battery Charger has been connected to the car
battery.
The screen starts to flash
Do not disconnect a charging clip wire during charging due to the danger of
sparking. First, remove the mains plug from the wall socket or wait until the
charge has been completed.
Once the charging is completed, for batteries permanently installed in
vehicles, follow these steps in the correct sequence:
1. Disconnect the Battery Charger from the mains.
2. Remove the negative charging clip (black) from the “-“ (negative) battery
terminal.
3. Remove the positive charging clip (red) from the “+“ (positive) battery
terminal.
4. Reconnect the vehicle’s positive connection cable to the positive battery
terminal.
5. Reconnect the vehicle’s negative connection cable to the negative battery
terminal.
WARNING:
WAARSCHUWING:
Stand by status:
