- Plug the drain hose into drain opening of the collection container.
- Plug the discharge hose into the drain valve outlet of the vac drum.
- Make sure drainage valve outlet is above the water level.
- Ensure that the hose lies straight,Avoid kink or bends caused by unevenness
ground.
- Switch to position II
- Use vac to remove debris
- It will vacuum until the unit is full and then stops while it automatically drains
through the discharge hose and then restarts (auto cycle)
Attention:
*Never operate it without foam filter and float body.(equip in factory)
*For vacuum much water,pls do not use the cloth filter,but with foam filter.
1) As a dry vacuum cleaner
- Release drum clamps, lift off lid and insert the wet and dry filter
bag into the top of the unit.
- Lock down lid with clamps.
- Remove drainage hose and fit drain valve lid to drainage valve outlet.
- Attach suction extension tubes and desired accessory.
- Switch to position I and vacuum debris until drum is full.
- Place it at a minimum distance of 1.5m from water
- Seal the drain opening of the collection container by means of the plug.
Attention:
*Never operate it without Cloth filter,foam filter and float body.(equip in
factory)
2) Start-up
Connect the unit to power supply.The unit is equipped with a power switch. Position
0 Switch off. Position I Continuous dry vacuum use. Position II Auto cycle mode, pond
vacuum use.
3) Accessories function
Floor nozzle:
suck water on the ground
Round brush:
for the removal of stuff soiling
Crevice nozzle:
for cleaning large, level surfaces
Pond Brush:
to remove pond sludge without taking in the pond gravel.
9. MAINTENANCE AND CLEANING
1) Standard cleaning
- Switch the product off on position 0 and pull off the power plug.
- Remove all hosed
- Remove the drain catcher bag and clean the rubbish
- Remove the drain hose
- Unlock the container lock remove the motor housing,remove the intake distributor
by turning and pulling it out of the bayonet closure.
