Street
Strider
Summit 8r / Sprinter 3r Owner’s Manual 9
To attach the left inboard rod end on the
aluminum steering linkage to the head tube
bracket, remove the nut from the rod end stud
(Fig. 3-4a)
, insert the nut into the slot on the
back side of the bracket
(Fig. 3-4b)
, push the
rod end stud into the hole to contact the nut, and
screw the stud in tight using the 12 mm open
end wrench
(Fig. 3-4c)
. Repeat the procedure to
attach the right front wheel
(Fig. 3-5a)
. When the
front wheels are attached, the front end should
appear as shown
(Fig. 3-5b)
.
Now that the front wheels are installed, you are ready to unfold the head tube and fix it
upright. This will require the 2 cap screws (male, black with 6 mm hex head) and 2
barrel nuts (female, silver with 5 mm hex head)
(Fig. 3-6a)
, located in the plastic bag
found in the small box
(the other screws in the bag are for the rear rack and the bottle
cage). Insert the barrel nuts into the left side of both bolt holes. Raise the head tube
into the full upright position
(Fig. 3-6b,c)
. Insert the short cap screw in the front middle
bolt hole and the long cap screw in the rear top bolt hole of the joint
(Fig. 3-6c)
. Using
the 5 mm hex wrench for the female side (left side) and the 6 mm hex wrench for the
male side (right side), securely tighten all three of the screws in the joint
(Fig. 3-7)
.
IMPORTANT: Keep the main frame rectangular packing foam piece to use when
folding your
StreetStrider
.
Figure 3-4. Attaching the two front wheels (con’t)
Figure 3-5. Attaching the two front wheels (con’t)
Unfolding the Head Tube
.
Figure 3-6. Unfolding the head tube
Figure 3-7. Unfolding the head tube
Positioning the Strider Poles
.
Figure 3-8. Positioning the strider poles
To adjust for rider size and preference, upper strider poles can be moved up and down by up to 2” as indicated by the limit line,
as well as rotated forward or backward in the lower strider pole insert tube. At the factory, the poles are set at the highest
position and rotated inward for packing. Use a 5 mm hex wrench to loosen the 2 screws in each clamp at the base of each strider
