®
6
W: www.streamline.systems E: [email protected] T: +44 (0)1626 830 830
W: www.streamline.systems E: [email protected] T: +44 (0)1626 830 830
7
4
Operating Warnings
Operating Warnings
Set Up Auto Calibrate
Important
Your battery is at risk of permanent damage if you disable low battery cut-off
and continue to use your controller for long periods when the battery voltage
has fallen below +10.5V.
Adjust the flow settings carefully. Repeated false dead-end detection indicates that the Cal value
should be increased (less sensitive).
For safety wire through the pump pressure switch. (The pressure switch can be bypassed if
absolutely necessary - the unit will protect itself under normal conditions.)
This is a WATER PUMP controller: it will not work with air in the system. Always prime the system
before starting work. If air in the system causes false dead-end detection, increase Cal value until air
is removed.
Do not set the Cal value too high. Setting it higher than necessary places extra strain on both the
pump and the controller in a dead end situation. This can result in damage to both the pump and
your controller.
Specification
Value
Supply Voltage
11 - 15 VDC
Maximum Current
15A
Typical Drive Current
8A
Voltmeter Accuracy
+ - 100mV
Enclosure Material
ABS
Water Resistance
IP65
Dimensions
115 x 65 x 40 (mm)
Working Temperature
0 - 40 Deg C
5
Set Up Auto Calibrate
Connect your hose and pole + brush to the pump.
Turn on the controller by pressing the power button.
Press and hold the up and enter buttons to
calibrate. CAL will be displayed.
To select Auto Cal continue to press the down
button until AUt is displayed. Press the enter
button to start. Auto Cal starts from C99.
After several moments the calculated CAL value
(e.g. C50) will be displayed and the controller is
ready to use. Press enter to exit calibration.
Press up until the display shows 30.
Display
Button
STREAMLINE
