Start-up and Use
Congratulations! You’ve connected your Stream Nano Drinking Water System and now
it’s ready for start-up. Here’s how:
1.
Dry off all the connections and the drinking water unit.
2.
Make sure that all the connections are tight, but do not over tighten.
3.
Turn the unit upside down to let out any trapped air.
4.
Turn the water onto COLD.
5.
Push the bypass lever of the diverter to start the flow of water through the unit. Allow the water to run
through the unit and diverter valve for one minute. Then close the bypass lever and shut off the
water at the faucet.
6.
Turn the unit right side up and set it on your counter and check all connections to make sure there
are no leaks.
7.
Turn on the water and push the bypass lever of the diverter to start the flow of water through
the unit again.
8.
Let the water run through for about 30 minutes to fully flush the filter and charge the carbon.
9.
Push the bypass lever inward to shut off the flow of water through the system. Then turn off the water
at your faucet and check for leaks.
7
Start-up and Use
03
Sec.
