©Copyright 2021 Strava Solutions, LLC All rights reserved
PAGE: 16
USB connector
Software Upgrades:
In the event a software upgrade is required, the manufacturer will provide
you with a new version of software to upload via USB stick.
•
Make sure the unit is off.
•
Remove the back panel of the unit by removing the four screws
with a #2 phillips screwdriver (cross tip)
•
Locate the USB connector. It will a black cable tethered to the
drain hose.
•
Insert the USB stick into the connector.
•
Turn the unit on.
•
The software upgrade is complete when the set up wizard
appears on the screen.
Step 3: Reassemble the unit
•
Fold the back panel into place, aligning the screw holes on either
side.
Figure 66
•
Re-insert the 2x 3/32” button head screws into the back panel.
•
Re-install the base pan by aligning it with the screw in
embossments and the back panel.
Figure 67
•
Using the 3/32”allen wrench or #2 Phillips screw driver,
tighten all 13 screws on base pan.
Step 4: Cure the unit
•
Carefully turn unit back over (being mindful of the glass).
•
Allow the unit to cure for a minimum of 24 hours before use.
Heating Element Replacement cont. :
Figure 66
Figure 67
