Preparation
Warning and Information Labels
Page 5
© Copyright 2020 Stratasys. All rights reserved.
Warning and Information Labels
The following labels appear on the air extraction system.
Preparation
Before installation, check the extraction system for damage. All packaging must be removed
before the system is connected to the power supply.
1. Move the system to the installation location and remove the outer packaging.
Labels
Meaning
Location
Goggles, gloves, and masks must be
worn when handling used filters.
Front of system.
Do not cover any vents or holes
adjacent to the label.
Bottom panel.
Electrical hazard. Removal of panels
with this label exposes electrical
components.
Bottom panel.
Warning. Turn the power to the system
off before opening the panel with this
label.
Near the cover
release clips.
If the system is used in a manner that is not specified by the manufacturer, the system
warranty is void.
Important:
Read all instructions in this manual before using this system.
• Intended use: This device is intended for indoor use only, to extract and filter
fume from a variety of 3D printers.
• Install this system in a well-ventilated area.
• If you intend to vent the air from the system directly into the room, place the
system at least 500mm (19.5 in.) from another object on the side of the air
outlet to ensure adequate airflow.
