15
Next File
When using a Play List, stop playing the current file and immediately skip to
the next file on the Play List. Only active when there is a "next file" available.
Play [Ctrl-P]
Same as the Play button. Begin playing the open MPEG file or the Play List.
Loop
Same as the Loop button. Repeatedly play the open MPEG file or the Play
List.
Slow Motion
Play the opened file in slow motion. Video may be played at 1/2, 1/3, 1/4, 1/5,
1/6, 1/7 or 1/8 actual speed.
Fast Forward
Same as the Fast Forward button. Play the video in fast motion. Since the
decoder card does this by playing I-frames only, the fast play speed will be
determined by the file’s IBP structure and bit-rate. In general, lower bit-rate
files will play faster than higher bit-rate files.
Still/Step [Ctrl-S]
Same as the Pause button. Pause the current MPEG file. Pressing or
selecting Pause again will step the file to the next frame of video. Press or
select Play to continue playing the file from the point where it was paused.
Stop & Rewind
Same as the Stop button. Stops playing the current file and “rewinds” it to the
beginning. However, if the current file is a File List, skip to the next item on
the list.
Reset
Reset the MPEG audio and video decoders. Only active when the decoder is
stopped. Primarily used for testing, this command is not normally needed.
Exit [Alt-F4]
Close all files and closes the application.
View
VGA On
Turn on or off the display of the decoder output on the VGA monitor.
Use Overlay Mode
Places the VGA card in overlay mode. If the VGA does not support overlay
mode, the warning box, “VGA card does not support overlay mode!” is
displayed.
