STOVES ST BI45 COMW, Руководство пользователя

Страница: 32 / 36

32
INSTALLING THE APPLIANCE
Before The Installation
Open the oven door and remove the accessories and packaging material.
Please make sure that the oven is not damaged in any way checking that the oven
door closes correctly and the inside of the door and front oven panel are not damaged.
Do Not Use the Oven : If the power cable is damaged, if the oven does not
function correctly or if it has been damaged or dropped. Place the oven on a flat
and stable surface prior to installation. The oven should not be installed close to
any heat source, radios or televisions.
During the installation, please make sure that the power cable does not come into
contact with any moisture or objects with sharp edges at the back of the oven. High
temperatures can damage the cable.
Warning: after the oven is installed you should
make sure the user can access the isolation switch.
This oven can only be used once it has been built into a housing unit, so that all
electrical components are shielded. The cabinetry must be able to withstand
temperature rises. The cabinet unit must be well ventilated with an air intake of 500cm
2
minimum cross-section in the plinth at the base of the unit. The shelf supporting the
oven must not go right back to the back wall of the housing unit – there must be a gap
of at least 100mm at the back to allow air to circulate. In a tall unit, any additional
shelves or drawers below the oven must also respect this 100mm gap.
Please note: Air vent is required in the plinth at foot of the base unit with a minimum cross section of 500cm
2.
There are 4 screw holes on the inner side of the oven door frame. Use the 4 wood screws to secure the oven into
the housing unit.