30
Connect to the gas supply
The inlet to the cooker is
1
⁄
2
” BSP
internal situated at the rear right corner.
Fit the bayonet connection. This should
be located so as to ensure that the
flexible connector hose does not kink.
Use a 900mm - 1125mm length of
flexible connector.
Ensure that all pipe work is of the correct
rating for both size and temperature.
Flexible connections should comply
with BS 669. Parts of the appliance
likely to come into contact with a
flexible connector have a temperature
rise of less than 70˚C.
After installation, make sure all
connections are gas sound.
Commissioning
Burner aeration
All burners have fixed aeration and no
adjustment is possible.
Pressure setting
G20 Natural Gas @ 20 mbar
Pressure test point
Use the oven injector.
Hob -
Turn the selected control k n o b
anticlockwise to the ‘full on’ position.
Push in the control knob and press the
ignition switch, until the burner lights.
Keep the knob depressed after the
burner has lit for up to 15 seconds for
the flame to establish. If the burner
flame fails to light, wait for at least one
minute before attempting to re-ignite.
Turn the control knob to the small
flame symbol and assess the low flame
stability.
Grill -
Open the top oven / grill door.
Push in and turn the top oven / grill
control knob clockwise to the ‘
FULL ON
’
position until the burner lights.
Keep the knob depressed after the
burner has lit for up to 15 seconds for
the flame to establish.
If the burner
flame fails to remain lit, wait for at
least one minute before attempting to
re-ignite..
Main Oven -
Push in and turn the
main oven control knob anticlockwise
to the ‘
FULL ON
’ position - Gas Mark 9
- until the burner lights.
Top Oven -
Push in and turn the top
oven control knob anticlockwise to the
‘
FULL ON
’ position - Gas Mark 9 - until
the burner lights.
Keep the knob depressed after the
burner has lit for up to 15 seconds for
the flame to establish. I If the burner
flame fails to remain lit, wait for at
least one minute before attempting to
re-ignite..
Before leaving the installation
1. Place all the loose parts of the
cooker into position.
2. Show the customer how to operate
the cooker and give them this
handbook. Thank you.
INSTALLATION INSTRUCTIONS
08 27241 01-61TGDO 1/7/05 9:10 AM Page 32