Whilst every care is taken to eliminate
burrs and raw edges from this product,
please take care when handling - we
recommend the use of protective
gloves during installation.
Moving the cooker
Please note that the weight of this
appliance is approximately
6 0 k g
(unpacked). Take care if the appliance
needs to be lifted during installation -
always use an appropriate method of
lifting.
Do not attempt to move the cooker by
pulling on the doors or handles. Open
the door and grasp the frame of the
cooker, taking care that the door does
not shut on your fingers.
Take care to avoid damage to soft or
uneven floor coverings when moving
the appliance. Some cushioned vinyl
floor coverings may not be designed
to withstand sliding appliances without
marking or damage.
Clearances & dimensions
Appliance dimensions
All sizes are nominal, and some
variation is to be expected. The
‘depth’ of the cooker, as given below,
is to the front of the door and
excluding knobs and handles.
depth:
600mm
width:
598mm
height recommended:
900 to 915mm
Note: this product may be raised to a
maximum of 930mm if required.
height with lid raised:
1 4 3 0 m m
Clearances
No shelf or overhang should be closer
than a minimum of 650mm, but check
with cooker hood manufacturer’s rec-
ommendations.
The cooker must have a side
clearance above hob level of 90mm
up to a height of 400mm.
Check that there are no projections
in the rear wall which will prevent
the lid being raised to the vertical
p o s i t i o n .
To avoid damage to surround-
ing units a 10mm gap should
be left between the appliance
and the units. If this is not pos-
sible, a kit (part number 01
25552 00) may be ordered
from Customer Care which will
protect the units.
For models with side opening doors,
we recommend a side clearance of
60mm between the cooker and any
side wall to allow the door to be
opened fully.
27
INSTALLATION INSTRUCTIONS
08 27241 01-61TGDO 1/7/05 9:10 AM Page 29
