STOVES 600CTH, Руководство пользователя

Страница: 9 / 28

7
To switch on a heater
Touch and hold the power on/off sen-
sor, shown below, for approximately
2 seconds.
Normal use:
With the display showing ‘0.’ and the
‘.’ flashing, any heater can be
switched on. Use the hob symbols
(shown on the previous page) to select
the burner you wish to use.
The display will change and the ‘.’
will stop flashing and remain lit.
By using the Plus and Minus sensors,
select the heat setting required - this
can be between 1 and 9.
Please note : The Plus and Minus will
control the display which shows the
‘.’
Heat Boost
When this function is activated, the
selected heater remains on full power
for a set period of time. This allows
the pans to heat up faster. After the
boost period is over the heater will
cycle on and off according to the tem-
perature set, between 1 and 8.
To activate this function:
Increase the heat setting past 9 - using
the Plus sensor.
The display will flash, showing both
the heat setting, and an ‘A’.
While the ‘A’ is flashing, the lower
heat setting can be entered, using the
Minus sensor.
The heat setting and the ‘A’ will con-
tinue to flash throughout the boost peri-
od.
When the heat setting and ‘A’ stops
flashing, the heater has returned to it’s
normal operating mode.
Please note : 9 is the
maximum set-
ting, therefore it is not necessary to use
the heat booster. If you should set the
heat booster, it will only come on for
10 seconds at the most.
Dual-Circuit Heaters
The inner element of dual-circuit
heaters is operated as for standard
heaters, as described in the “Normal
Use” and “Heat Boost” sections.
To use the full heater (both inner and
outer elements), first set the inner ele-
ment to the desired heat setting as
above, then touch the “dual on/off”
sensor to bring the outer element on as
well. The dual circuit LED will come
on. The heat setting can be adjusted
using the “
+ ” and “ - ” sensors as
required.
To return to just the inner element,
touch the “dual on/off” sensor again.
USING THE HOB