Stout Designs TB-001, Руководство по эксплуатации

Страница: 2 / 39

Operating tips: VERY IMPORTANT
• Always run TRAILBLAZER at full throttle when cutting.
• Make sure the kill switch somewhere close to you so you can shut the machine down in the event you need to. (i.e. if you
get the saw in a bind or your around bystanders.)
• If you get the saw in bind and the belts slip or start stalling the motor, the first reaction you should have is to reverse
backwards or use the kill switch.
• Always walk away from the blade side while the blades are running.
•
Don't let debris build up to heavy on top of the motor as the debris could get hot and ignite if left on top of the engine.
• Try to always use 91 or better non-ethanol fuel.
• Always tighten your blades with an impact wrench. A hand wrench will not tighten them enough.
• Never tighten the set screw on the clutch assembly jaw coupling (this coupling is designed to slip if needed). All other
setscrews on the bearings, drive shaft jaw coupling and clutch housing can be tightened and should be checked prior to use.
picture of setscrew to never tighten to follow.
• Visually Check to make sure Blue Spider is locked in place as shown in picture to follow
Note: if used on public trails, roads or pathways, please always use with caution and always use a lead and
trail vehicle to alert any potential oncoming public vehicles that trail maintenance equipment is near.