Storz C-MAC S, Инструкция по эксплуатации

Страница: 16 / 28

Application
Instructions for use • C-MAC S PEDIATRIC IMAGER • PNO713_EN_V1.0_03-2021_IFU_CE-MDR 16
6 Application
6.1 Using the C-MAC S IMAGER
The high-intensity light emitted by the C-MAC S IMAGER can result in increased
temperatures at the light outlet. However, these always stay below the value which could
cause burns.
6.2 Function of the multifunction button
The multifunction button on the C-MAC S PEDIATRIC IMAGER can be used to activate single
image capture and video recording for documentation purposes. Documentation with the
multifunction button on the C-MAC S PEDIATRIC IMAGER can be performed in conjunction
with the C-MAC monitor 8403ZX and C-MAC PM 8403XD.
Approx. 5 seconds after the C-MAC PM 8403XD is switched on each time, a blue bar is
displayed at the top of the screen for a few seconds. It is now possible to record data for
documentation purposes. The remaining memory capacity in minutes is shown on the
left-hand side, while the name of the directory in which the saved data is stored is shown
on the right. If memory capacity is less than 10 minutes, the bar is displayed in orange-
red.
Data can only be stored on the C-MAC monitor 8403ZX or 8404ZX if there is an SD
memory card inserted into the monitor.
Single image capture
Briefly press the multifunction button to activate single image capture.
ð
The current image on the screen is saved on the SD memory card inserted into the
connected monitor 8403ZX/8404ZX or in the internal memory of the C-MAC PM
8403XD.
ð
During single image capture, the multifunction button briefly lights up green and then
switches back to blue.
Video recording
2. Press the multifunction button for around 2 seconds to start video recording.
ð
The video recording is saved on the SD memory card inserted into the connected
monitor C-MAC monitor 8403ZX or in the internal memory of the C-MAC PM 8403XD.
ð
During video recording, the multifunction button flashes green. A flashing red dot
appears in the top-left corner of both monitor screens.
3. Press the multifunction button again to stop the video recording.
ð
The video recording stops.
ð
The multifunction button switches to blue and the flashing red dot goes out.
The video stream can only be viewed on a PC if an MPEG 4 codec is installed on the PC.