Storz 201340 20, Руководство по обслуживанию

Страница: 32 / 59

4.1 Information about replacements
The device is fully adjusted and tested before it leaves the manufacturers. If the device fails, a test of the
assemblies should be carried out by authorized KARL STORZ technical staff.
4.2 Tools required for replacing the individual
assemblies
– Power supply
Phillips screwdriver, medium
Needle nose pliers
Conductive work mat, wristband, ground cable
– Fan assembly
Phillips screwdriver
Needle nose pliers
Standard screwdriver
Conductive work mat, wristband, ground cable
– Lamp
Phillips screwdriver, medium
Torx driver and assorted bits
Thermal compound
Conductive work mat, wristband, ground cable
– Attenuator assembly
Phillips screwdriver
Torx driver and assorted bits
Needle nose pliers
Standard screwdriver
M3 hex wrench
Conductive work mat, wristband, ground cable
– Condenser lens
Phillips screwdriver
Torx driver and assorted bits
Needle nose pliers
Standard screwdriver
M3 hex wrench
Conductive work mat, wristband, ground cable
– Hot mirror assembly
Torx driver and assorted bits
Conductive work mat, wristband, ground cable
XENON NOVA
®
300
MODEL 20
1340 20
4-2
06.11 / V1.6
Caution: Always unplug the device from the power supply before carrying out any
repairs on it!
After servicing, a safety test or the leakage current and protective ground
resistance measurements according to IEC 62353, IEC / UL 60601-1, CAN /
CSA C22.2 NO 601.1, whichever may apply, are to be carried out.
To prevent damage to the components caused by the build-up of electrostatic
charges, we recommend that you connect yourself to ground via the
wristband throughout servicing.