12
5.4.2 0 - 10 Volt (+) DC control
a) Put the cable from the desk or the cable remote into the XLR socket at the back of
the machine [3].
b) Put the pump up to 99% and adjust the required fan output at the machine (see
chapter 4.4.2.1).
c) With the turnable button on the cable remote or with the fader on the analogue
desk the pump output can be regulated.
z?f{}~{eEe||y~w~{ywx{{ {w~{~w{ y{Dj~{}{{
Active-LED [18] will be lit.
Connect the
Unique 2.1
to an analogue desk or the cable remote which you can get
as an option, using the XLR socket at the back of the machine [3].
Please note
: With analogue control the pump can be adjusted from the desk and/
or the cable remote. The fan has to be adjusted at the machine.
5.4.2.1 Adjusting the pump and fan output
a) Press the Mode-button [14] at the control panel until a P and two figures appear on
the LED display [17] (see Fig. 1). Put the pump up to 99%.
b) Press the Mode-button [14] at the control panel until an F and two figures appear
on the LED display [17] (see Fig. 2).
c) Adjust the desired data (1 - 99%) by pressing the Up- or Down-button [15].
d) The data for the pump can be regulated/adjusted via the turnable button on the
cable remote and the fader on your analogue desk.
5. Operating the Unique 2.1
5.4.1.2 Adjusting the pump and fan output
If you run the machine via a DMX desk you can adjust the pump and the fan directly
from the desk from 1 to 99%.
The adjusted channel controls the pump, the following one controls the fan.
5.4.1.1 Adjusting the DMX start address
a) Press the Mode-button [14] at the control panel until three figures appear on the
LED-display [17] (see Fig. 3).
b) Adjust the required start address by pressing the Up- or Down-button [15].
c) Save the start address by pressing the Enter-button [16] once. The start address will
now also be saved when you disconnect the machine from the mains supply.
Содержание UNIQUE 2.1
Страница 2: ...1 Operating manual a Look Solutions product UNIQUE 2 1 ...
Страница 21: ...20 a Look Solutions product ...