Engineering Manual for
AXS Series S60 Keypads
S60 Engineering Manual
Page 9 of 12
Rev 1.6 May 2016
© Copyright Storm Interface. 2016. All rights reserved
Configuration
On power-up, you have the option to
-
change the wiegand format,
-
change the site code, or
-
reset to defaults.
Power up and press the ‘#’ key within 3 sec and the red led will start flashing, then enter the engineering code ‘#725’.
On acceptance, the green LED will be displayed for 2 seconds and the buzzer will sound a confirmation beep.
If the unit is left unattended during programming then after 10 seconds it will timeout and drop back into Entry Mode.
To Enter Programming Mode, press
# 725
To change
Wiegand format
Press
1
To select
4 bit format
Press
1
To select
26 bit format
Press
3
To select
8 bit format
Press
2
To select
32 bit format
Press
4
To reset to factory
defaults
Press
2
To change
Site Code
Press
3
Enter the new 5
digit site code
To exit programming menu
Press
0
Power up and press
#
within 3 seconds
For 32 bit Wiegand, the
site code
must be less than or equal to
‘65535’.
For 26 bit communication the site
code must be less than or equal
to ‘00255’.
Keypad is back in
Entry Mode , RED LED
is on
To select
8/32 bit format
Press
6
To select
4/32 bit format
Press
5
