Storch Compact ProCut, Руководство пользователя

Страница: 87 / 112

87
Thereafter, you unlock the locking bolt (no. 26, fig. 8) and with the aid of the lock lever for reproducible cuts (no. 10a,
fig. 6) you position the corner cutter at the desired height, position the foam board onto the left bearing rail (no. 14, fig.
6), switch the corner cutter on by means of the on / off switch , and evenly slide the foam boards from the left to the
right through the corner cutter.
WARNING:
Guide the plate without significant pressure through the corner cutter so that the wire does not break.
Fig. 12
2. Rafter cutouts
Following taking the mitre and performing the cut as
described before, measure and transfer the dimension of
the rafter height and width onto the foam board. Positi-
on the right marking below the cutting wire and switch
the corner cutter on at the ON / OFF button. Unlock the
locking bolt (no. 26, fig. 8), guide the corner cutter towa-
rds the bottom as far as to the desired point, slide the
foam board until the marked rafter width towards the
right side, and guide the corner cutter to the top again,
until it locks in standby position.
TIP:
You can limit the depth dimension of the rafter by means
of the lock lever for reproducible cuts.
Translation of the original instruction